PG County Rental Lead Inspection

The MD Lead Law requires pre-1978 rental properties to have a lead certificate. A full risk reduction is completed to receive the certificate. Only visual inspectors or risk assessors can perform this inspection. We recommend the inspection take place before new tenants move in. After the tenants move out, this inspection must be redone before any new tenants move in.

Inspection Process

1. Visual

   During the inspection, the inspector completes a visual. The inspector checks the condition of all painted surfaces. The inspector presumes all paint contains lead. As a result, all paint must be intact. There can be no damaged paint on any surfaces. Meaning no peeling, chipping, or flaking paint. This includes interior and exterior surfaces. It is a requirement because the original paint may be present. The lead paint may exist beneath several layers of paint. Fixing deteriorating paint needs to occur prior to the inspection. For the inspection to continue the visual must pass.

   Avoid the following

   

   Steel lintel chipping paint

   

   Peeling paint on deck

   

   Peeling paint on garage door

   

   Deteriorating paint on rake board

   

   Chipping paint on handrail

   

   Peeling paint on railing

   

   Deteriorating paint on steps

   

   Flaking paint on wall

   

   Flaking paint on radiator

   

   Chipping paint in window well

   

   Peeling paint on door stop

   

   Flaking paint in common hall
2. Collection of Dust Wipe Samples

   The inspector collects at least one sample from every room. Bedroom, bathroom, kitchen, dining room, family room, powder room, hallway, garage, den, office, laundry room, rec room, enclosed patio, and basement are all considered rooms. All rooms accessed by tenants should be accessible to the inspector.

   The inspector will take a sample from the floor or window sill. A window well sample is taken only if there is a wood window. Make sure wood windows are easily opened. View sample locations.

   New lead dust standards went into effect on July 1, 2020. The standards are lower. Dust wipes samples for floors are to be below 10 µg/ft². Dust wipe samples for window wells and sills are to be below 100 µg/ft². To achieve this, clean floors, window sills, and window wells before the inspection. Use a HEPA vacuum to clean all dust and debris. Follow with wet wiping on non-carpeted surfaces. Use plenty of clean rinse water.

3. Lab Analysis

   The samples are sent to an accredited lab. The lab will check for high levels of lead contaminated dust. They will provide a report of the levels of each sample. After the report is returned, the inspector will analyze the results. All floor samples must be below 10 µg/ft². All window well and window sill samples are to be below 100 µg/ft². If any samples failed, only the areas that failed are retested. You have 30 days from the initial inspection to pass.

   
   
4. Lead Certificate

   After passing the inspection, the owner will receive a lead certificate. The certificate is emailed. Keep the certificate for your records and provide a copy to your tenants. This certificate is required for a rental license. The certificate is only good for the new tenants or current tenants. Once the tenants move out and before new tenants move in, the inspection must be completed again.

   

Educational Materials

Provide your tenants with a copy of the certificate. Send your tenants EPA’s pamphlet Protect Your Family from Lead in Your Home. Give them MDE’s pamphlet, Notice of Tenant’ Rights. Send documentation every two years if your tenants remain the same.

MDE Tracking Number

A tracking number is required for a lead certificate. You can get this tracking number by calling Maryland Department of the Environment at 410-537-4199.

What to do if you fail the inspection?

If you fail the visual, fix any damaged paint. If you fail the dust wipe sampling, reclean the areas that failed. Use a HEPA vacuum to clean all dust and debris. Follow with wet wiping on non-carpeted surfaces. Use plenty of clean rinse water.

At times, bare concrete floors are hard to pass. If cleaning did not work, painting unfinished concrete floors and applying a sealant usually works. If the paint on the concrete floor starts to deteriorate in the future fix it prior to the next inspection.

Reschedule the inspection to have the inspector retest areas that failed. You have 30 days to pass the inspection.

© 2026 Lead Check Pro. All Rights Reserved. Terms